RP-3R Clip-on sampling pump with 4” rubber nipple, 10’ hose and probe (up to 40’ hose available) Logs user ID, station ID, Calibration & Bump Test history, Alarm Events & Alarm Interval TrendsĪlligator clip, protective rubber boot, charger, and calibration adapter 105 g) with rubber boothĮxplosion proof, dust and water resistant to IP-66/68 (2m,1h) approval. 61 W x 67 H x 27 D mm), 3.70 ounces (approx. 58 W x 65 H x 26 D mm), 3.52 ounces (approx.
#BREATHING ZONE CD FULL#
25 hours after a 3 hour full chargeĪTEX, CSA, (MED certification, part # 72-RA-C-MED)Ģ.2” W x 2.55” H x 1.02” D (Approx. 40☌ ~ +60☌, 0 to 95% RH, non-condensing (temporary environment, 15 minutes) 20☌ ~ +50☌, 10 to 90% RH, non-condensing (continuous environment) Trouble alarm: Flashing LEDs, intermittent buzzer (95 db 30 cm), display of error message Gas Alarm: Flashing LEDs, continuous buzzer (100 db 30 cm), flashing gas value, vibration
Trouble alarm: Sensor disconnection, low battery, circuit error, calibration range error Gas Alarm: 3 Increasing alarms, STEL, TWA, overscale alarm.
#BREATHING ZONE CD PLUS#
*GX-3R with MED certification, part # 72-RA-C-MED Gas Detectedĭiffusion sampling standard (hand aspirator or clip-on motorized pump optional)ĭigital LCD displays with 7 segment plus 14 segment plus icon The 3 LED lights will continue to flash once every 30 seconds until the non-compliance condition has been resolved. The instrument flashes it’s 3 LED lights every 30 seconds in the following conditions if the instrument has not been bump tested, or if calibration is due, or if there was a gas alarm event. Safety supervisors will appreciate the non-compliance indicator. H2S and CO are now available in a combo micro sensor. The new O2 sensor is electrochemical with a 3 to 5 year life span. If one filament gets poisoned the second filament takes over. The LEL sensor has a unique design with two active filaments in one sensor to increase it’s resistance to silicone poisoning. The GX-3R represents the latest evolution of gas detection technology utilizing a new generation of micro sensors. It simultaneously monitors and displays LEL combustibles, O2, CO (Hydrogen compensated CO also available), and H2S. The GX-3R is the worlds smallest 4 gas monitor weighing only 3.52 ounces and can comfortably be clipped within a worker’s breathing zone (2.2” W x 2.55” H x 1.02” D). Now there is a 4 gas monitor smaller than many single gas monitors. Traditionally this means only a single gas monitor would be small enough for a worker to practically wear a gas monitor ‘In the breathing zone’.
Air sampling filters may be attached to the collar or lapel. OSHA defines the breathing zone as a ten inch radius around the worker’s nose and mouth, and requires that worker exposure monitoring air samples be collected in the breathing zone.
0 kommentar(er)
